Brother HL-720 manual Test Print Mode, Lamp Lit Choice Function

English: HL-YL User’s Guide, Chapter 3

USER’S GUIDE

Test Print Mode

The printer has the following test print mode. Follow these steps:

1.Make sure that the top cover is closed.

2.Hold down the switch and turn on the power switch. Keep the switch depressed until the Drum lamp comes on.

The Drum lamp lights to indicate that the printer is in the test print mode.

3.Press the switch again to execute the test print or hold down the switch to select another option and release the switch to execute the selected option.

The test print mode varies depending upon the printer model as follows:

Lamp Lit	Choice	Function
Drum	Test sample page	The printer prints a test sample page.
		The printer returns to the ready status after
		printing.
Alarm	Print Config & Print	The printer prints the current configuration of
	Fonts I	the printer and a list of the internal fonts.
		The printer returns to the ready status after
		printing.(HL-730 series only)
Ready	Factory Reset	The printer is restored to the factory setting and
		permanent fonts and macros are cleared.
		The printer returns to the ready status after
		printing.(HL-730 series only)
Data	Hex Dump Print	The printer can print data as hexadecimal values,
		so that you can check data errors and problems.
		To exit from this mode, you have to turn off the
		printer. (HL-730 series only)

3–4