Assembling

IMPORTANT: Finish Assembly Before Connecting to Amplifier

For protection, this A7 loudspeaker is shipped with the horn assembly fixed inside the cabinet. For optimum sound quality, follow the assembly steps below for repositioning the horn assembly on top of the loudspeaker cabinet.

Step 1

If you would prefer to keep the horn assembly positioned inside of the cabinet, please proceed to the next section “Placing Stereo Loudspeakers”.

Step 2

Remove the rear panel by using a 5/32” hex key to remove the bolts around the perimeter of the rear panel. Be aware that the crossover network is attached to the rear panel and that wires connect the crossover network to the drivers in the cabinet. Take care not to apply tension to those connecting wires.

Step 3

Reach in behind the high frequency horn assembly and disconnect the wires.

Step 4

Support the horn assembly during removal. Using a 3/8” socket or wrench, gently remove the nuts, washers and bolts holding the horn assembly inside the cabinet. Keep track of the nuts, washers and bolts for later use.

Step 5

Attach the front mounting bracket to the pre-drilled holes on top of the loudspeaker using the supplied bolts.

Step 6

Attach the horn mounting bracket to the sectoral horn to create the horn assembly.

Step 7

Position the horn assembly on top of the cabinet over the pre-drilled holes. Using a 3/8” socket or wrench, attach the horn assembly to the cabinet using the same bolts, washers and nuts.

Step 8

Unscrew the plug on the top of the rear panel. Thread the high frequency horn assembly wires through the unplugged hole on the top of the rear panel.

030519 A7 Owner's Manual