Furuno FAX-30 manual FAX Operation PC, Starting receiving, Stopping receiving, Channel setup menu

3.FAX OPERATION: PC

3.1Automatic Receiving

3.1.1Starting receiving

1. At the facsimile standby display, click CHANNEL SETUP on the top menu.

CHANNEL SETUP
ZONE	1: NORTHWEST PACIFIC
STATION	0: JMH/TOKYO 1
CHANNEL	AUTO
FREQUENCY	03622.5	kHz
OK
RCV STOP
< back

Channel setup menu

2.Click the arrow button on ZONE and choose desired zone.

3.Click the arrow button on STATION and choose desired station. See page AP-2 for station number.

4.Click the arrow button on CHANNEL and choose desired channel. Choose AUTO if you are unsure of channel. (Most stations transmit the same message over several frequencies, so if you are unsure of the channel choose AUTO.)

5.If necessary you may fine tune the frequency. Click anywhere inside the FREQUENCY box and enter frequency.

6.Click OK and then click “<back” or Back button to return to the top menu.

Then, the FAX-30 will receive the next scheduled broadcast from the station selected. When the FAX-30 receives the start signal from the facsimile station it automatically adjusts itself to match speed, IOC (Index of Cooperation) and phase of the station’s transmitter. After a facsimile image is received it is compressed and stored in the image memory and then posted on the facsimile standby display screen. This process takes 3-5 minutes.

3.1.2Stopping receiving

You may stop receiving at any time by doing the following:

1.At the facsimile standby display, click CHANNEL SETUP on the top menu.

2.Click RCV STOP.

3-1