Airlink AWLL6080 user manual Configuring the Adapter

Page 14

3. Configuring the Adapter

This section describes how to connect your wireless adapter to a wireless network.

Note to Windows XP Users:

You must disable the Wireless Zero Configuration Utility in order to use the bundled Wireless Utility. Please follow the steps below to disable XP’s wireless utility. Windows Vista users can skip the following instructions and go to Step 1

Double-click on the Wireless Network Connection Icon in the system tray and then click on Properties or Advanced.

When the new wireless network connection properties window appears, go to the Wireless Networks tab, uncheck the “Use Windows to configure my wireless network settings” check box and click OK.

14

Image 14

Contents 300N Draft 802.11n Wireless USB Adapter Table of Contents Introduction Package ContentsFeatures Installation Install Driver & UtilityPage Page Page Page Select Install the software automatically and click Next Page Click Finish Verify Driver Installation Page Configuring the Adapter Page Page Page Page Wireless Monitor Wireless InformationAP List Profile Settings Page Configuring Encryption Click on Profile Settings then NewPage Configuring WEP encryption Configuring WPA/WPA2-PSK Encryption for home users Select WPA/WPA2-PSK from the Set Security Option boxConfiguring WPA/WPA2 Encryption for corporate networks Select WPA/WPA2 from the Set Security Option boxConfiguring 802.1x authentication for corporate networks Select 802.1x from the Set Security Option boxAd-hoc and Peer-to-Peer Wireless Networks Open the Wireless Monitor Page Wi-Fi Protected Setup WPS Page Page Page Page Click Continue on the router configuration screen About Appendix a Specifications Appendix B Information Federal Communication Commission Interference StatementEuropean Union Notice Technical Support Mailsupport@airlink101.com