Agilent Technologies U2781A manual Safety Symbols, Regulatory Markings

Page 3

Safety Symbols

Direct current

Caution, risk of danger.

Regulatory Markings

The CE mark shows that the product complies with all the relevant European legal

Directives (if accompanied by a year, it signifies when the design was proven).

The CSA mark is a registered trademark of the Canadian Standards

Association. A CSA mark with the indicators "C" and "US" means that the product is certified for both the U.S. and Canadian markets, to the applicable American and Canadian standards.

The UL Mark is a registered trademark of Underwriters Laboratories Inc. UL listing mark with the indicators "C" and "US indicates the product compliance with both Canadian and U.S. requirements.

The C-tick mark is a registered trademark of the Spectrum Management Agency of Australia. This signifies compliance with the Australian EMC Framework regulations under the terms of the Radio Communications Act of 1992.

This product complies with the WEEE Directive (2002/96/EC) marking equipment. The affixed product label indicates that you must not discard this electrical/ electronic product in domestic household waste.

ICES/NMB-001

This ISM device complies with the Canadian ICES-001.

 

U2781A User’s Guide

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Agilent U2781A USB Modular Instrument Chassis WA R N I N G Regulatory Markings Safety SymbolsThis Guide… Declaration of Conformity Regulatory Information for Australia/New Zealand Contents Contents Getting Acquainted Introduction Features Checking the ContentsApplications Product Outlook Operating Environment General SpecificationsPower Supply AC Input Electrical SpecificationsPhysical Layout Mechanical SpecificationsGetting Acquainted Installation T E Mount Kit InstallationModular Chassis Installation Hardware Requirements System RequirementsSoftware Requirements DAQ Driver InstallationInstalling the USB DAQ driver Installation Click Finish when the installation is completed Hardware Verification Agilent Measurement Manager Software InstallationInstallation Features and Functions Features and Functions USB Backplane SSI timing signal Functionality2USB backplane block diagram Trigger Bus 3Block diagram of Trigger Bus0...7 and Trigger OutExternal Trigger In Star Trigger Trigger OutSystem Reference Clock 5Block diagram of temperature monitoring and fan control Chassis Temperature MonitoringFan Speed Monitoring Identifying Modules Location Georgraphical AddressModules Identification SYSTCDES? Simultaneous Synchronization SSI 7Synchronization between modules in the chassis Features and Functions General Maintenance General Maintenance Contact us
Top Page Image Contents