Linksys PAP2T manual Enter 1 to enable

Internet Phone Adapter with 2 Ports for Voice-over-IP

Interactive Voice Response Menu

Action	Command	Choices	Description
	(press these
	keys on the
	telephone)
Enable/Disable DHCP	101	Enter 1 to enable	Enable or disable the Phone Adapter’s
		Enter 0 to disable	DHCP feature. If your network router
			assigns IP addresses, enter 1,
			otherwise, enter 0.
Check IP Address	110	—	Use this command to check the
			current IP address of the Phone
			Adapter.
Set Static IP Address	111	Enter the IP address	To set a static IP address, the DHCP
		using the numbers on	feature must be disabled. If the DHCP
		your telephone	feature is enabled, you will hear,
		keypad. Use the	“Invalid Option,” if you try to set a
		* (star) key to enter a	static IP address.
		decimal point.
Check Network Mask	120	—	Use this command to check the
(or Subnet Mask)			current network mask of the Phone
			Adapter.
Set Network Mask (or	121	Enter the network	To set the network mask, the DHCP
Subnet Mask)		mask using numbers	feature must be disabled. If the DHCP
		on your telephone	feature is enabled, you will hear,
		keypad. Use the	“Invalid Option,” if you try to set the
		* (star) key to enter a	network mask.
		decimal point.
Check Static Gateway	130	—	Use this command to check the
IP Address			current gateway IP address of the
			Phone Adapter.
Set Static Gateway IP	131	Enter the IP address	To set a static gateway IP address, the
Address		using numbers on	DHCP feature must be disabled. If the
		your telephone	DHCP feature is enabled, you will hear,
		keypad. Use the	“Invalid Option,” if you try to set a
		* (star) key to enter a	static gateway IP address.
		decimal point.
Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu				9

Using the Interactive Voice Response Menu