Linksys WPC100 manual FCC Statement, FCC Radiation Exposure Statement, Safety Notices

Page 33

Appendix E

Regulatory Information

Appendix E: Regulatory Information

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•• Reorient or relocate the receiving antenna

•• Increase the separation between the equipment or devices

•• Connect the equipment to an outlet other than the receiver’s

•• Consult a dealer or an experienced radio/TV technician for assistance

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. IEEE 802.11b or 802.11g operation of this product in the USA is firmware-limited to channels 1 through 11.

Safety Notices

•• Caution: To reduce the risk of fire, use only No.26 AWG or larger telecommunication line cord.

•• Do not use this product near water, for example, in a wet basement or near a swimming pool.

•• Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

WARNING: This product contains lead, known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling.

Industry Canada Statement

This Class B digital apparatus complies with Canadian ICES-003 and RSS210.

Operation is subject to the following two conditions:

1.This device may not cause interference and

2.This device must accept any interference, including interference that may cause undesired operation of the device. This device has been designed to operate with an antenna having a maximum gain of 2dBi. Antenna havingahighergainisstrictlyprohibitedperregulations of Industry Canada. The required antenna impedance is 50 ohms.

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the EIRP is not more than required for successful communication.

Industry Canada Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

RangePlus Wireless Notebook Adapter

30

Page 32 Page 34
Image 33
Page 32 Page 34
Contents RangePlus Wireless Notebook Adapter Icon Descriptions About This GuideOnline Resources Copyright and TrademarksTable of Contents LEDs Chapter Product OverviewChapter Wireless Security Checklist General Network Security GuidelinesAdditional Security Tips How to Access the Wireless Network Monitor Chapter Advanced ConfigurationWi-Fi Protected Setup StatusEnter the Adapter’s PIN Number Use the Push ButtonWireless Network Status Connect Wireless Network StatisticsNo Wi-Fi Protected Setup Wireless Security DisabledWireless Security Enabled WEP Wired Equivalent Privacy Use the Push Button Enter Key Manually Wireless Security DisabledWireless Security Enabled Profiles Available Wireless NetworksProfile Information Create a New ProfileNo Wi-Fi Protected Setup Wi-Fi Protected Setup Use the Push Button Enter the Adapter’s PIN Number Enter Key Manually Network Settings screen appears Advanced SetupWEP WPA Personal WPA2 PersonalWPA Enterprise Peap WPA2 EnterpriseRadius Congratulations! The profile is Successfully configured RangePlus Wireless Notebook Adapter does not work properly Appendix a TroubleshootingEnvironmental Appendix B SpecificationsWindows XP Wireless Zero Configuration Appendix C Windows XP Wireless Zero ConfigurationWireless Network Connection Limited Warranty Obtaining Warranty ServiceExclusions and Limitations Technical Support FCC Statement Safety NoticesFCC Radiation Exposure Statement Industry Canada StatementAvis d’Industrie Canada Wireless DisclaimerDansk Danish Miljøinformation for kunder i EU Regulatory Information Norsk Norwegian Miljøinformasjon for kunder i EU Regulatory Information Software Licenses Software in Linksys ProductsPreamble ScheduleSoftware License Agreement Software License Agreement No Warranty Original SSLeay License OpenSSL License8041010C-DF
Top Page Image Contents