Alcatel Carrier Internetworking Solutions LC-2G24FP installation instructions Part May

OmniAccess 6000 LC-2G24FP Installation Notes: Installation Guide

Before beginning, read the entire procedure. Make sure you understand all the precautions in these installation instructions.

2Disconnect all cables attached to the line card.

3Loosen the module’s fastening screws.

At the front of the Alcatel Wireless LAN Switch, use a #2 Phillips or cross-head screwdriver to loosen both of the fastening screws on the faceplate of the installed line card. The screws loosen with counter-clockwise rotation, but are captive and cannot be fully removed.

4Remove the line card.

CAUTION—If removing a line card from Slot 1, make sure that the fastening screws for the module in the slot above it are fully secured. If the module in Slot 3 is loose, it could interfere with the module removal and possibly damage the components.

Grasp the module handle firmly and draw the line card forward from its slot. There may be moderate resistance as the module comes free from its connections with the chassis backplane, but do not use excessive force. Once disengaged from the backplane, the line card should easily slide out the rest of the way.

5Cover blank slots.

For safety considerations, as well as to promote proper airflow for cooling and to prevent dust from entering the switch chassis, cover any unoccupied slot with a blank cover plate

6

Part 031659-00 May 2005