Port and Cable Specifications
FE Port
The FE port provides a 10/100 Mbps Ethernet connection to a network. The RJ-45 female connector port pin-outs are shown below:
10/100 Mbps Ethernet RJ-45 Female | | | |
| | | | | | | | | | Pin-Out | 1 | | | | ETH Rx+ | (POE negative*) |
| | | | | | | | | | | | | | | | | | | | |
| | | | | | | | | | | | | | | | | | 2 | | | | ETH Rx– | (POE negative*) |
| | | | | | | | | | | | | | | | | | | |
| | | | | | | | | | | | | | | | | | 3 | | | | ETH Tx+ | (POE positive*) |
| | | | | | | | | | | | | | | | | | 4 | | | | Serial TxD** | (POE positive*) |
| | | | | | | | | | | | | | | | | |
| | | | | | | | | | | | | | | | | | 5 | | | | Serial TGND** | (POE positive*) |
| | | | | | | | | | | | | | | | | | 6 | | | | ETH Tx– | (POE positive*) |
| | | | | | | | | | | | | | | | | | 7 | | | | Serial RxD** | (POE negative*) |
8 | Serial RGND** (POE negative*) |
Direction | *POE optional |
Input |
Output | **Serial optional |
The port accepts a 4- or 8-conductor Category 5 UTP Ethernet cable with an RJ-45 male connector. A straight-through cable is required for connection to a network port. A crossover cable is required for connection to a management workstation.
For cables that run through plenums or air-handling spaces as described in NEC (2002) Article 300.22(C), the cable should be suitable under NEC Article
800.50and marked accordingly for use in plenums and air-handling spaces with regard to smoke propagation, such as CL2-P, CL3-P, MPP or CMP. Be sure to install cables in accordance with all applicable local regulations and practices.
Alcatel OmniAccess 6000 LC-2G24FP Installation Instructions 7