TABLETOP SOLUTIONS
INSTALLING YOUR PNP300/350 | 6 |
PNP300:
Step 1. Cut an opening into the table’s surface. Refer to the ALTINEX website at
www.altinex.com for the cutout requirements.
Note: The table can be 0.25 in (6 mm) to
3.75in (95 mm) thick. Always confirm dimensions before cutting to ensure that specifications have not changed.
Step 2. Place the support brackets under the
AC power cable Black RCA cable Red RCA cable Yellow RCA cable Black
Red
=AC power
=audio left
=audio right
=composite video
=computer video
=serial data
=network
=telephone/modem
table and place them between the support mount grooves on the side of the PNP300/350 unit. Attach the brackets to the groove at the desired height and secure them to the bottom of the table using the setscrew. There are two support brackets, one for each side of the unit.
See DIAGRAM 3 for details.
Step 3. Secure the cables by using the provided cable clamps of the type shown below.
Step 4. Pass the power cord from the bottom of the housing and attach it to the bottom of the table using the cable clamp and screw supplied with the PNP300/350. Do not clamp the cord too tight or too loose.
See DIAGRAM 4 for an example of cable mounting the cables.
Step 5. Connect the appropriate cables with the correct input connectors on the bottom of the unit. The following standard connections are provided:
A round gray cable is also provided for connection to a stereo audio line.
PNP350: |
|
|
AC power cable (2) | = | AC power |
Red | = | for independent |
|
| network connections |
|
|
|
OPERATION |
| 7 |
7.1 OPERATING THE POP-UP PANEL
To raise the unit, push down on the center of the top cover of the PNP300/350 until a click is heard and then let go. The connector panel will pop up to allow access to the connectors.
To lower the unit, disconnect all cables on the front connector panel. Then push down on the center of the top cover until the latch engages and the unit is locked in place.
9 |