D-Link DFE-690TXD manual Networking Basics, Check your IP address

Page 18

Appendix A - Networking Basics

Networking Basics

Check your IP address

After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e router) automatically. To verify your IP address, please see follow the steps below:

Windows® 2000/XP: Click on Start > Run. In the run box type cmd and click OK.

Windows Vista® / Windows® 7: Click on Start > All Programs > Accessories > Command Prompt.

At the prompt, type ipconfig and press Enter.

This will display the IP address, subnet mask, and the default gateway of your adapter.

If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some firewall software programs may block a DHCP request on newly installed adapters.

D-Link DFE-690TXD User Manual

18

Image 18
Contents Page Table of Contents Package Contents System RequirementsIntroduction About Fast Ethernet About Auto-negotiation LED Indicators Features Hardware Overview 100M Link/Act10M Link/Act Installation Software Installation Click Install DriversHardware Installation Windows 7/Vista Users Windows XP UsersWindows 2000 Users Verify Installation Windows 7 Click on Start Control Panel StepNetwork Connections Installation Installation Troubleshooting How do I know if I have a Cardbus controller on my laptop?Networking Basics Check your IP addressStep Highlight Internet Protocol TCP/IP and click Properties StepTechnical Specifications Standards TemperatureContacting Technical Support Phone SupportWarranty Limited WarrantyLimited Software Warranty Non-Applicability of WarrantyWhat Is Not Covered Disclaimer of Other WarrantiesTrademarks Limitation of LiabilityGoverning Law Copyright StatementCE Mark Warning FCC StatementRegistration
Related manuals
Manual 57 pages 10.79 Kb