D-Link DWL-2000AP manual Important Note

Page 53

Governing Law: This Limited Warranty shall be governed by the laws of the State of California. Some states do not allow exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the foregoing limitations and exclusions may not apply.This limited warranty provides specific legal rights and the product owner may also have other rights which vary from state to state.

Trademarks: D-Link is a registered trademark of D-Link Systems, Inc. Other trademarks or registered trademarks are the property of their respective manufacturers or owners.

Copyright Statement: No part of this publication or documentation accompanying this Product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Corporation/D-Link Systems, Inc., as stipulated by the United States Copyright Act of 1976. Contents are subject to change without prior notice.

Copyright© 2002 by D-Link Corporation/D-Link Systems, Inc. All rights reserved.

CE Mark Warning: This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment; such modifications could void the user’s authority to operate the equipment.

(1)The devices are restricted to indoor operations within the 5.15 to 5.25GHz range. (2) For this device to operate in the 5.15 to 5.25GHz range, the devices must use integral antennas.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The antenna(s) used for this equipment must be installed to provide a separation distance of at least eight inches (20 cm) from all persons.

This equipment must not be operated in conjunction with any other antenna.

Register your D-Link product online at http://support.dlink.com/register/

(05/09/05)

53

 

Image 53
Contents DWL-2000AP Contents Package Contents WPA IntroductionConnections LEDs Features Wireless Basics Wireless Basics Standards-Based Technology Installation Considerations Link AirPro DWL-G650 Getting StartedLink AirPlus Xtreme G DWL-2000AP Getting Started Setting up a WirelessHome Wizard Using the Configuration MenuChannel Home WirelessKey Type- Select HEX or Ascii KeysIP Address Subnet Mask Gateway Apply Home LANAdvanced Mode Wireless Client mode Using the Configuration Menu Tools Admin Load Settings from Save Settings toRestore to Factory Tools SystemTools Firmware Firmware UpgradeStatus Log Status Device InfoHelp Status StatsNetworking Basics Using the Network Setup Wizard in Windows XPNetworking Basics Enter a Computer description and a Computer name optional Networking Basics Networking Basics Next Networking Basics  Right-click on My Computer Naming your ComputerComputer name Checking the IP Address in Windows XPControl Panel Assigning a Static IP Address in Windows XP/2000Properties Connections Click Properties Assigning a Static IP Address Windows XP/2000 Click Apply Now Assigning a Static IP Address with Macintosh OSX Select Built-in Ethernet Selecting a Dynamic IP Address with Macintosh OSXSystem Preferences Checking the Wireless Connection by Pinging in Windows XP Checking the Wireless Connection by Pinging in Windows MeTroubleshooting Default Manager  Go to Start My Computer Properties  SelectAdapters TroubleshootingWhy can’t I get a wireless connection? Why does my wireless connection keep dropping?Forgot my encryption key Resetting the DWL-2000AP to Factory Default Settings ResetTechnical Specifications Technical Specifications Power Input Media Access ControlWeight WarrantyTechnical Support Warranty and Registration Page Important Note