D-Link DSL-360T user manual Setup New Connection Bridge window

DSL-360T ADSL Modem User’s Guide

7.The Encapsulation values LLC (SNAP) and VC (MUX) are two different methods of encapsulating the PPP packet. Contact your ISP to make sure which encapsulation is being supported.

8.For most users, the remaining settings will not need to be changed. See your ISP for further information.

9.Click the Apply button when you have entered all the information. The browser window may briefly go blank. After a few seconds the new connection you just configured will become the active connection for the Modem.

10.To make your temporarily saved connection permanent, click the Save All button in the System Commands window on the Tools tab.

Bridge

Make sure you have selected Bridge from the Type: pull-down menu so that you are now configuring setting in the menu titled “Bridged Connection Setup”. Follow the instructions below to set up the connection.

Figure 3-6. Setup – New Connection (Bridge) window

To configure the WAN connection for Bridge, perform the steps listed below. Some of the settings do not need to be changed when you first set up the device but can be changed later if you choose.

22