D-Link DWL-510 manual Important Note

Page 57

Trademarks: D-Link is a registered trademark of D-Link Systems, Inc. Other trademarks or registered trademarks are the property of their respective manufacturers or owners.

Copyright Statement: No part of this publication or documentation accompanying this Product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Corporation/D-Link Systems, Inc., as stipulated by the United States Copyright Act of 1976. Contents are subject to change without prior notice. Copyright© 2002 by D-Link Corporation/D-Link Systems, Inc. All rights reserved.

CE Mark Warning: This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of eight inches (20cm) between the radiator and your body.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

Register your D-Link product online at http://support.dlink.com/register/

Version L2

Rev.120502

57

Page 56 Page 57
Image 57
Page 56 Page 57
Contents LinkAir DWL-510 Contents Package Contents Introduction Product Features & Benefits LEDs Wireless Basics Standards Based Technology Installation ConsiderationsWireless Basics Getting Started Getting Started IP Address Using the Configuration Utility Link Info Configuration IP Setting Assigning a Static IP Address Site Survey Site Survey Add Ssid Service Set IdentifierAbout Troubleshooting Status AdaptersComputer does not recognize the DWL-510 Wireless Adapter Cannot connect to the access point or the wireless routerDWL-510 Link lights are not on Uncheck Hide extension for known file types click on ApplyPage Networking Basics Using the Network Setup Wizard in Windows XPNetworking Basics Enter a Computer description and a Computer name Networking Basics Networking Basics Networking Basics Networking Basics Windows XP Naming your ComputerComputer Select Properties and click Computer Name Tab in the System Properties windowSelect Workgroup and enter the name of the Workgroup Checking the IP Address in Windows XP/2000 Type CommandNetwork Connections Control PanelProtocol TCP/IP Area Connections Click PropertiesClick OK For Windows XP Checking the Wireless Connection by PingingAdding and Sharing Printers in Windows XP Adding a local printerPrinters and Faxes Click on Add a printer Select Use the following port Select Local printer attached to this computerNetworking Basics Adding a local printer Go to Start Printers Faxes Add a Printer Sharing a network printerSelect Browse for a printer PrinterNetworking Basics Sharing a network printer Network Setup Wizard on all the network computers Local Printer Sharing an LPR printerEnter the Printer IP Address and the Port Name, as shown Select Create a new portClick Settings Click Have Disk Order to share Printer Other Tasks Technical SpecificationsPower Specifications Diagnostic LEDPhysical Dimensions TemperatureContacting Technical Support Link Technical Support over the Telephone 877Link Technical Support over the Internet Warranty and Registration Page Important Note
Top Page Image Contents