3Com 100 PCI manual Secure the NIC with the screw you removed in step

Page 6

6ETHERLINK 10/100 PCI FOR COMPLETE PC MANAGEMENT NICS QUICK GUIDE

Figure 1 Installing the NIC

1 Remove slot cover

2 Insert NIC

SOS pin connector

System Management

Bus (SMB) connector

Remote Wake-Up (RWU) connector

PCI slots

7Secure the NIC with the screw you removed in step 5.

If you want to connect the Remote Wake-Up cable, see “Connecting the Remote Wake-Up Cable” in Chapter 2 of the user guide to continue the installation.

If you want to connect a cable from the SOS or SMBus connector, see your PC documentation or contact your PC manufacturer for instructions.

If you do not want to connect a cable, continue with step 8.

8Replace the PC cover and plug in the power cord. Do not turn on the power to the PC.

Image 6

Contents Etherlink 10/100 PCI for 3Com Corporation 5400 Bayfront Plaza Santa Clara, California Installation Overview IntroductionRunning the Preinstallation Program Installing Multiple NICsInstalling the NIC Secure the NIC with the screw you removed in step Installing the Driver and Software Turn on the power to the PCIf the Update Device Driver Wizard starts If the New Hardware Found dialog box appearsYou must restart the PC to complete the installation Insert the Windows 95 CD or diskette, and then click OKInsert EtherDisk diskette 1 in drive A, and then click Next Insert the Windows 98 CD or diskette, and then click OKClick Finish Verifying Successful Installation