Installing storage drives
Optical
drive
1.Place the chassis upright, then remove the upper 5.25” drive bay metal plate cover.
2.Insert the optical drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay.
3.Secure the optical drive with two screws on both sides of the bay.
4.Connect the IDE (A) and power
(B) plugs to connectors at the back of the drive.
| 2 |
3 | 3 |
|
B
A 
Floppy
disk drive
1.Place the chassis upright, then remove the lower 3.5” drive bay metal plate cover.
2.Insert the floppy disk drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay.
3.Secure the floppy disk drive with two screws on both sides of the bay.
4.Connect the signal (A) and power (B) plugs to connectors at the back of the drive.
Hard
disk drive
1.Place the chassis upright, then remove the upper 3.5” drive bay metal plate cover.
2.Insert the hard disk drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay.
3.Secure the hard disk drive with two screws on both sides of the bay.
3
3
2
B
A
3
3
2
Installation
manual
