Kodak P20 manual Overview, Installing the Batteries

OVERVIEW

Flashtube

Housing

Battery

Door

	MANUAL	LCD Panel
Mode Button		Zoom Button
Power Switch		Ready Light/
Knurled Lock Ring		Test Button
		Hot Shoe
		Contact

	LCD Panel
Mode function	MANUAL	Power Ratio
		Zoom Focal
Auto OK		Length

Battery Level

Flash Range

Scale

INSTALLING THE BATTERIES

The flash uses two 1.5V AA batteries (not included) and is compatible with alkaline, Ni- MH, oxy-alkaline, and most AA rechargeable batteries. We recommend using Kodak Ni- MH rechargeable digital camera batteries when possible.

1.Slide the power switch to the “OFF” position.

2.Open the battery compartment by sliding the battery door back slightly toward the rear of the unit to unlatch it, then flipping down the door.

3.Insert 2 AA size batteries into the battery compartment

according to the polarity indications “+ –”. The flash will not operate if the batteries are installed incorrectly.

4.Close the battery door. When the unit is switched on, it will start charging with a slight humming sound and the Ready Light will come on when charging is completed.

NOTE: The flash is ready to fire as soon as the Ready Light is lit. However, full power will not be available

for several seconds. Wait a few seconds after the Ready Light activates to achieve maximum output.

If it takes longer than 30 seconds for the Ready Light to come on after the flash is fired in Full Power Mode, replace the batteries.

CAUTION Turn the flash unit off before

mounting on or detaching from the camera. If it is turned on, the flash unit may self-fire, or damage to the flash unit may result.

Battery Status

Full	Icon is displayed during power-up and upon waking
	from the Standby state.
Low	Icon is displayed constantly.
Empty	Icon blinks constantly.

3