Asus VS238N/H, VS247N/H manual Detaching the arm/stand for Vesa wall mount, To detach the arm/stand

Page 12

2.1Detaching the arm/stand (for VESA wall mount)

The detachable stand of the VS228/VS238/VS247 Series LED monitor is specially designed for VESA wall mount.

To detach the arm/stand:

1.Disconnect power and signal cables. Carefully put the front of the monitor face down on a clean table.

2.Use your fingers gently pull away the plate that covers the stand neck. Use a screwdriver to remove the four screws that secure the stand to the monitor.

3.Detach the stand from the monitor.

We recommend that you cover the table surface with soft cloth to

prevent damage to the monitor.

Hold the stand of the monitor while removing the screws.

• The VESA wall mount kit ( 100 x 100 mm) is purchased separately.

Use only the UL Listed Wall Mount Bracket with minimum weight/ load according to the model listed in the specification table (Screw size: M4 x 12 mm).

2-1

Chapter 2: Setup

Image 12
Contents VS228D/N/H VS238N/H VS247N/H Table of contents Federal Communications Commission Statement Safety information Care & Cleaning Following symptoms are normal with the monitorWhere to find more information Asus websites Optional documentationPackage contents WelcomeConnecting cables Assembling the monitor baseTo assemble the monitor base Make sure to screw the base to the arm tightlyMonitor introduction Front of the LED monitorStatus Description Rear of the LED monitor Detaching the arm/stand for Vesa wall mount To detach the arm/standAdjusting the monitor OSD On-Screen Display menu SplendidSelect the image color you like from this function Image Input SelectSystem Setup Adjust the system configuration 1/2 2/2Specifications ModelTroubleshooting FAQ Possible SolutionSupported Timing List Vesa / IBM Modes Support Timing D-SUB, DVI-D, Hdmi inputsHdmi 1.3 CEA-861 Formats Supported Timing for Hdmi input