2.2- WIRING MCS CONTROLLERS - CONT.
MCS Controller DIP Switch Configuration
When connecting MCS Controllers to the
Controllers should be configured to reflect their correct Zone ID.
Figure 7 |
|
| DIP SWITCH # | 4 | |
|
|
| |||
1 | 2 | 3 | |||
1 | X | ON | ON | ON | |||
|
| #1 OFF=Back |
|
|
|
| |
2 | OFF | ON | ON | ||||
X | |||||||
|
| Light ON |
|
|
|
| |
| 3 | X | ON | OFF | ON | ||
4 | X | OFF | OFF | ON | |||
|
| #1 ON=Back |
|
|
|
| |
5 | Light OFF | ON | ON | OFF | |||
X | |||||||
6 | X | OFF | ON | OFF | |||
NOTE: If more than one MCS Controller is to be installed in a single zone, all wiring should be paralleled (as illustrated in Figure 6C on the previous page) and both MCS Controllers should be assigned the same Zone ID.
Page 10 | © Channel Plus, Inc. 2004 • All rights reserved. 4/04 |