If a problem occurs ...
Error checklist
Problem | Possible cause | Possible solution |
|
|
|
No display | The receiver’s power | Check if the receiver is |
indication | supply is interrupted | correctly inserted into |
|
| the camcorder |
|
| (see page 6) |
|
| or check if the |
|
| GA |
|
| adapter is correctly |
|
| mounted (see page 7) |
|
|
|
No RF | No RF signal: | Set transmitter and |
signal | transmitter and | receiver to the same |
indication | receiver are not on | channel |
| the same channel |
|
|
|
|
| No RF signal: | Reduce the distance |
| the transmitter is out | between transmitter |
| of range | and receiver |
|
|
|
RF signal | The receiver’s | See “Adjusting the |
indication | squelch threshold is | squelch threshold – |
available, | adjusted too high | SquELH” on page 17 |
no audio |
|
|
signal |
|
|
|
|
|
Audio | The transmitter | Adjust the |
signal has | sensitivity is | transmitter |
a high level | adjusted too low | sensitivity correctly |
of back- |
|
|
The maximum | Reduce the distance | |
ground | effective range of the | between transmitter |
noise | RF link has been | and receiver |
| reached |
|
|
|
|
Audio | The transmitter | Adjust the |
signal is | sensitivity is | transmitter |
distorted | adjusted too high | sensitivity correctly |
|
|
|
| The receiver is | Increase the distance |
| overmodulated | between transmitter |
|
| and receiver (see |
|
| page 21) |
|
|
|
If a problem occurs that is not listed in the above table or if the problem cannot be solved with the proposed solutions, please contact your local Sennheiser agent for assistance.
20