CONTROLS, INDICATORS, AND TERMINALS
FRONT PANEL
SPKR |
| LEVEL | INPUT | OUTPUT | SENS | MODE | FREQ | BOOST | REMOTE | ||
| |||||||||||
|
|
|
|
|
|
|
| 60 |
| 180 |
|
R
MIN | MAX HPF OFF LPF 30 | 300 | 0 | +18 |
|
|
|
L
| Figure 1: Front Panel Terminals and Controls |
1. FILTER MODE SELECT SWITCH (MODE) | |
"HPF": | Slide switch to this position if the amplifier is used as a mid/tweeter amplifier. |
"OFF": | Slide switch to this position if the amplifier is used as a |
"LPF": | Slide switch to this position if the amplifier is used as a subwoofer amplifier. |
2.
3.BASS BOOST CONTROL (BOOST)
Select a boost level between 0 dB and +18 dB to enhance the bass performance of your sound system.
4.INPUT SENSITIVITY LEVEL CONTROL (SENS)
The input sensitivity level can be varied from 5.0 volts to 100 mV depending on the output voltage of the source unit (refer to
5.HIGH IMPEDANCE INPUT (RCA)
To be connected to RCA
6.LOW IMPEDANCE INPUT (SPKR LEVEL)
To be connected to speaker outputs from a source unit (i.e. radio, tape deck or CD player) when RCA outputs are not available.
7.LINE LEVEL OUTPUT
This output can be used to connect to another amplifier for system expansion. Note: This line level output is full range.
8.REMOTE SUBWOOFER LEVEL INPUT
To be connected to the optional RS remote subwoofer volume control.
www.coustic.com
| REAR PANEL |
| |
11 12 10 | 9 | 13 | 14 |
PWR / PRT |
|
|
|
|
|
|
FUSE | + | L | - | + | R | - |
|
GRD REM B+
BRIDGE
Figure 2: Rear Panel Terminals and Indicators
9.POWER AND PROTECT INDICATOR (PWR/PRT) Green light indicates that the amplifier is "ON".
Red light indicates either a high current, short circuit or DC offset is detected at the speaker outputs. The amplifier will revert to normal operation once the problem is rectified.
This indicator also lights up at a high operating temperature. Under this condition, the amplifier will automatically shut down. As soon as the temperature falls to a safe level, the amplifier will automatically resume operation.
10.POWER INPUT TERMINAL (B+)
To be connected to the positive terminal of the vehicle’s battery or other constant +12 V source.
11.GROUND INPUT TERMINAL (GND)
To be wired to the vehicle’s chassis for ground.
12.REMOTE TURN-ON INPUT TERMINAL (REM)
To be connected to the remote control wire or power antenna lead of the source unit for remote ON/OFF.
13.FUSE RECEPTACLE
14.LEFT/RIGHT SPEAKER OUTPUT TERMINAL For connection to the speaker system.
4 | 5 | |
|
|
|