Connect the Amplifier to the Speakers. Use thicker speaker wires (e.g. 8 - 10 gauge desirable) for these connections.
For Stereo Mode
1.Connect the left negative
2.Connect the left positive ("+") speaker output of the amplifier to the positive terminal of the left speaker.
3.Connect the right negative speaker output of the amplifier to the negative terminal of the right speaker.
4.Connect the right positive speaker output of the amplifier to the positive terminal of the right speaker.
| + L | - |
|
| + |
| R - |
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
BRIDGE
Figure 7: Stereo Connection
For Bridged (Mono) Mode
1.Connect the left positive ("+") speaker output of the amplifier to the positive input terminal of the speaker.
2.Connect the right negative
3.Make sure that BOTH RCAs (left/right) are plugged in, otherwise bass response and output will suffer.
| + L - |
|
| + R - |
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
BRIDGE
Figure 8: Bridged Single Woofer Connection
CAUTION: ANY DEVIATION FROM THE ABOVE SPEAKER CONNECTION MAY CAUSE SERIOUS DAMAGE TO THE AMPLIFIER AND/OR SPEAKERS. PLEASE DOUBLE CHECK THE CONNECTION BEFORE TURNING THE SYSTEM ON.
10
www.coustic.com
Connect the Amplifier to the Battery
Heavy gauge wire is preferred. Add a fuse or circuit breaker to any power wire that runs through firewall or sheet metal to protect the battery, the vehicle, and more importantly, you. It is highly recommended that installation is carried out by an authorized Coustic dealer.
Connect the Amplifier Remote Control
Connect the remote input terminal of the amplifier to the remote output terminal of the source unit to establish amplifier remote on/off through the power on/off of the source unit. If the source unit does not provide a remote output, connect to its power antenna lead or other switched
Connect the Amplifier Ground to Vehicle Chassis
Find a good ground spot in the vehicle and connect the ground terminal of the amplifier to this point via a large gauge ground cable.
Reconnect the Battery Ground to the Vehicle Chassis
Double check all the previous installation steps, in particular, the wiring and component connec- tion. If everything is in order, complete the installation by reconnecting the battery ground to the vehicle chassis.
Optional RS Remote Subwoofer Level Control
If the optional remote subwoofer level control (model RS) is used, connect the plug of the RS to the port on the end panel of the amplifier.
T | SENS | MODE | FREQ |
| BOOST | REMOTE |
|
| 60 | 180 |
|
|
|
| MIN | HPF OFF LPF 30 | 300 | 0 |
| +18 |
| MAX |
|
|
| ||
|
|
|
|
|
|
Figure 9: Remote Subwoofer Level Control.
11