Cool mode
Install the exhaust hose (see page
Drainage nozzle “CLOSE position” Stopcock (Upper)
1. Press the MODE button to select COOL mode.
COOL DEHUM FAN VENT
2.Press the ON/OFF button to start operation.
•The red OPERATION lamp on the unit will illuminate. Make sure they are securely attached.
3.Press the TEMPERATURE button to set the desired temperature.
•The temperature can be set within the range of 18°C to 32°C.
4. Press the FAN button to set the desired fan speed.
AUTO QUIET LOW HIGH
To turn off
Press the ON/OFF button again.
• The red OPERATION lamp on the unit will turn off.
NOTES:
•To minimise noise it is recommended that during cooling mode the drainage nozzle should remain in the CLOSE position.
•To prevent water saturation ensure that stopcocks are always fitted when not using separate drainage.
electrolux EXP09CS1WI installation of window kit 13
Dehumidification mode
In this mode, the air conditioner dehumidifies the room
1.Remove the exhaust hose (see page
2.Turn the drainage nozzle to the OPEN position.
Drainage nozzle
Stopcock (Upper)
“OPEN position”
3.Pull the stopcock (upper) out from the drainage nozzle.
•When the stopcock (upper) is removed, a small amount of water may be discharged from the drainage nozzle.
•Always perform this procedure with the unit turned off. Drain water will squirt out if attempted during operation.
4.Insert the hose clamp into a standard commercially- available hose (12.7mm inner diameter, 16.7mm outer diameter).
Hose clamp
Drain hose
5.Attach the hose to the drainage nozzle, and secure it with the hose clamp.
•Depending on room condition, approximately 28 litres of water per day (24 hours) will be dehumidified. Prepare some kind of bucket of appropriate size to collect drain water, or take some appropriate measure to drain the water outside of the room, so that drain water will not overflow or soak your room.
•Set the hose sloping downwards for easier drainage. Moreover, do not bend the hose at any point, nor allow the end to be submerged in water.
