installationoperating conditions/energyand removal of exhausttips/incluhoseionselectroluxelectroluxEXP09CS1WIEXP09CS1WI
Installation and removal of exhaust hose
Installation only together with “window kit”
The exhaust hose must be installed or removed in accordance with the usage mode indicated in the table below
Mode | Exhaust hose |
Cool, fan, ventilation | Install |
Dehumidification | Remove |
Installation of the exhaust hose
1.Attach the window exhaust adapter to the exhaust hose
•Extend one end of the exhaust hose and insert it into the window exhaust adapter, and turn it (approx. three times) until it stops.
•Make sure they are securely attached.
Window exhaust adapter
Extend
Exhaust hose
2.Attach the exhaust hose couple to the unit
•Insert the two projections on the exhaust hose couple into the two holes on the unit, and firmly attach them to each other.
Exhaust hose couple
Projection
Hole
3.Slide and open the exhaust cover on the window panel, and attach the window exhaust adapter
•Surface of window exhaust adapter marked “TOP” should be at the top when it is installed in a doublehung sash window.
•Surface of window exhaust adapter marked “TOP” should be on the window frame side when it is installed in a sliding sash window.
“TOP”
The exhaust hose should be as short as possible for opera- tional efficiency; however, it must not be twisted or bent.
Unacceptable
Acceptable
Acceptable
Removal of the exhaust hose
1.Remove the window exhaust adapter.
•Pull out and remove the window exhaust adapter by pushing down the two “PUSH” markings, and slide and close the exhaust cover in the window panel.
“PUSH”
2.Remove the exhaust hose couple from the unit.
•Lift up and remove the exhaust hose couple from the unit by pushing down on the two projections.
