Bosch Appliances EX36-IP installation manual Unpacking, Faceplate removal

4 en EX36-IP

1.1Unpacking

Parts list (items supplied with unit)

-EX36IP Infrared Imager™ Assembly

-Installation Instructions booklet

-Allen Key

-Software CD

Items required for installation

(not supplied with units)

-Mounting hardware

-Mounting tools

-PC/Laptop with RJ45 Ethernet port

-Power supply

1.2Initial Preparations

1.) Determine the operating voltage at the installation site. The camera‘s Voltage Regulator Board accepts 12-24VAC / VDC input without change to internal connections.

2.) Determine the optimum mounting location for the camera. See Section 2, Mounting the unit.

3.) All cameras have been tested and pre-focused with telephoto setting as factory default prior to shipment. If any adjustment needed, it is advisable to check the camera’s operation before installation

4.) Install IP Camera Software on PC.

2.Mounting the unit

2.1Faceplate removal

The faceplate must be removed prior to the installation process. This is necessary because the mounting holes need to be accessed. The lens may need to have its directional angle changed.

1.) Place the camera housing on a flat surface.

MAN36IPB Rev.0 2008.10 Quick Install Bosch Security Systems