Figure 2-4: Attaching the mounting brackets to a 5.25" device
2.Unfasten and remove the cover plate of the device tray.
3.Insert the device with attached mounting brackets into the device tray.
4.Fasten the mounting brackets to the device bay, and then fasten the cover plate (for internal devices only).
5.Open the back cover of the chassis, and connect the cables to the installed device and to the rear transition board.
6.Close the back cover.
2.3.5 Installing a 3.5" Floppy Disk Drive
A space is reserved for a 3.5" floppy disk drive on the top of the device bay. Follow the procedures below to install a 3.5" floppy disk drive.
1.Fasten one pair of mounting brackets to both sides of a 3.5" floppy disk drive. Note that the guide edges of the mounting brackets should be on the lower side.
2.Unfasten and remove the top cover plate of the device tray.
3.Insert the floppy disk drive with attached mounting brackets into the device tray.
4.Fasten the mounting brackets to the device bay.
5.Open the back cover of the chassis, and connect the cables to the installed device and to the rear transition board.
6.Close the back cover.