EMC LPE11002EG installation manual Removing the Bracket

3. Remove the computer case.

Note: For best I/O performance, place the adapter into an empty PCIe x4 or higher slot. PCIe slots are shorter than standard PCI 64-bit slots. Do not attempt to plug the adapter into a standard PCI slot.

4.Remove the blank panel from an empty PCIe bus slot. Follow steps 5–8 to change the bracket if they are different sizes. Otherwise, skip to step 9.

Note: The HBA comes with a standard PCI bracket installed. A low-profile bracket is included in the box with the HBA. The low-profile mounting bracket is shorter than the standard bracket; approximately 3.11 in. (7.9 cm) compared to 4.75 in. (12.06 cm) long.

5. Remove the mounting bracket screws from the top of the HBA.

Figure 2: Removing the Bracket

6.Remove the bracket and store it for future use.

7.Align the new mounting bracket tabs with the holes in the HBA.

Note: Be careful not to push the bracket past the transceiver housing's grounding tabs. Make sure the light emitting diodes (LEDs) are properly aligned with the holes in the bracket.

8.Replace the screws that attach the HBA to the bracket.

9.Insert the HBA into the empty x4 or higher PCIe bus slot. Press firmly until the adapter is seated.

10.Secure the HBA's mounting bracket to the case with the panel screw or clip.

11.Replace the computer case and tighten case screws.

The HBA is now installed in the PC and is ready for media attachment.

LPe11002 Hardware Installation Manual Page 4