1.Connect the Wireless Access Point to a Broadband connection (i.e., a Cable modem or a DSL modem.)
2.Install the C54U Wireless USB Stick Adapter in the computer(s) on your wireless network
3.Check the Device Manager to confirm that the wireless adapter is installed correctly. Please refer to the Networking Basics section in this manual entitled: Checking the Installation of the Drivers for the Wireless Adapter.
4.Set the Static IP Address of the wireless adapters if Multiple Dynamic IP are not used.
Note: The IP Address for all computers must be in the same IP Address range, and the Subnet Mask must be the same for all the computers on the network. For example: If the first computer is assigned an IP Address of
10.0.0.2with a Subnet Mask of 255.0.0.0, then the second computer can be assigned an IP Address of 10.0.0.3 with a Subnet Mask of 255.0.0.0, etc.
If you are using a PPPoE client (Point to Point Protocol over Ethernet), please contact your ISP (Internet Service Provider) for further instructions regarding connecting to the Internet.
13