QS.2 Functional Description

Quick Start Guide

Use a twisted-pair telephone line to connect two RJ-11 or terminal block ports between two Hardened Ethernet Extenders.

WARNING: Inappropriate operation might damage the terminal block.

•Meets NEMA TS1/TS2 environmental requirements: temperature, shock, and vibration for traffic control equipment.

•Meets EN61000-6-2 & EN61000-6-4 EMC Generic standard Immunity for industrial environment.

•Operates transparent to higher layer protocols such as TCP/IP.

•Ethernet port: Supports IEEE 802.3/802.3u/802.3x. Autonegotiation: 10/100 Mbps, full-/half-duplex; Auto MDI/MDI-X.

•Complies with IEEE 802.3at standard for high power input required device and also compatible with IEEE 802.3af powered devices (Only available for Hardened IEEE 802.3at PoE PSE Ethernet Extender version.)

•Ethernet Extender port (RJ-11 and terminal block): Symmetrical on the VDSL, full-duplex 50-Mbps communications link over existing copper telephone line.

•One DIP switch for configuring Local (Loc) and Remote (Rmt).

•Ten speeds with speed indicator LEDs on front panel of unit, up to 50 Mbps @ about 984 feet (300 meters), down to 1 Mbps @ about 6232 feet (1900 meters.

•4-port 10/100BASE-TX (2-port IEEE 802.3at PoE PSE) Ethernet Extender: 2.88 A @ 24 VDC, 1.44 A @ 48 VDC. Power

consumption: 69.12 W Max.

•2-port IEEE 802.3at PoE PSE Ethernet Extender: 2.88 A @ 24 VDC, 1.44 A @ 48 VDC. Power consumption: 69.12 W Max.

•1-port IEEE 802.3at PoE PSE Ethernet Extender: 1.6 A @ 24 VDC, 0.8 A @ 48 VDC. Power consumption: 38.4 W Max.

•4-port 10/100BASE-TX Ethernet Extender: 0.36 A @ 24 VDC, 0.18A @ 48 VDC. Power consumption: 8.64 W Max.

•Power Supply: Redundant 24-48 VDC terminal block power inputs and 48 VDC. DC jack with 100–240 VAC external power supply.

•Field Wiring Terminal Markings: Use copper conductors only, 140/167° F (60/75° C), wire range 12-24 AWG, torque value

7 lb-in.

•Operating temperature range @ -40 to +167° F (-40 to +75° C). Tested for functional operation @ -40 to +185° F

(-40 to +85° C). UL® 508 Industrial Control Equipment certified. Maximum surrounding air temperature @ 167° F (75° C).

•For use in Pollution Degree 2 Environment.

•Supports DIN rail, panel, and rackmounting installation.

QS.3. Assembly, Startup, and Dismantling

•Assembly: Place the Hardened Ethernet Extender on the DIN rail from above using the slot. Push the front of the Hardened

Ethernet Extender toward the mounting surface until it audibly snaps into place.

•Startup: Connect the supply voltage to start up the Hardened Ethernet Extender via the terminal block (or DC jack).

•Dismantling: Pull out the lower edge and then remove the Hardened Ethernet Extender from the DIN rail.

Page 8

724-746-5500 blackbox.com