EN
GETTING STARTED
BATTERIES
Batteries for the remote and main units are supplied with this product. Replace them whenever the low battery signal ( 
) displays. Remove the battery compartment lid on the bottom of the main unit, and insert the batteries. Use a small Phillips screwdriver to remove the remote unit compartment lid. Be sure to match the correct polarity, as shown in the battery compartment. Before you close the lid, press the RESET button with the point of a blunt object (such as a ball point pen).
8
NOTE Insert the batteries in the remote unit before you set up the main unit. Do not use rechargeable batteries.
AC POWER ADAPTER
An AC power adapter is supplied for use with the main unit. You must connect the power adapter if you wish to use the continuous backlight feature. The jack is located in the battery compartment.
NOTE If the AC power becomes unavailable, the unit will automatically switch to battery power.
SWITCH BETWEEN MODES
Press SELECT.The select mode will flash. The display will stop flashing if no key is pressed within 5 seconds.
| 10 | 8/8/03, 11:35 AM |