Lathem 5000E manual Lathem Time Corporation

Page 2

WARNING

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his or her own expense.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS A LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE RADIO INTERFERENCE REGULATIONS OF THE CANADIAN DEPARTMENT OF COMMUNICATIONS.

LE PRÉSENT APPAREIL NUMÉRIQUE N'ÉMET PAS DE BRUITS RADIOÉLECTRIQUES DÉPASSANT LES LIMITES APPLICABLES AUX APPAREILS NUMÉRIQUES DE CLASSE A PRESCRITES DANS LE RÈGLEMENT SUR LE BROUILLAGE RADIOÉLECTRIQUE ÉDICTÉ PAR LE MINISTÈRE DES COMMUNICATIONS DU CANADA.

1.The details of this User's Manual are subject to change even without previous notification.

2.This User's Manual has been prepared with the utmost care to cover all aspects of the time clock's use.

3.Be sure to use your time clock after you have fully understood the hardware and software specifications and limits.

4.No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, mechanical, photocopying, recording or otherwise.

This User's Manual and its contents are copyrighted by LATHEM TIME CORP. with all rights reserved.

Lathem Time Corporation

www.lathem. com

(800)241-4990

Image 2
Contents Lathem Time Corporation Lathem Time Corporation Features Before Using Your Time Clock Attached AccessoriesPrint Position on Time Card ConfigurationLocation of Name Quick Easy Setup StepHOW to Program the Clock DIPSW1 DIPSW2Setting the Time ExampleSetting the Date Setting the Starting Daylight Saving Time Setting the Ending Daylight Saving Time Number Repeat Times SET Setting the NumberInitial Number SET Number Reset Preprogramed Comments Setting Press the SW2 key until the correct number appearsSetting the Password Registering the PasswordHOW to Change Settings When Password is SET Canceling the Password Left or Right Print Print Method SettingPrint Switch Type of AN Hour LeadingNumber of Year Digits Type of LanguageWall Mounting Replacing Ribbon CassetteDIP Switch Setting DIPSW1 DIPSW2Print example Specifications Main Function