1200 Series User’s Manual
Changing the Motor
Figure 6
1.Unplug cord from wall outlet.
2.Remove type section from main frame (see “Replacing the Type Section”).
3.Figure 6 shows a close-up of cam block terminal.
4.Disconnect Motor Wire Leads – 6.1 by turning each Screw – 6.2 one-quarter of a turn counterclockwise.
5.Remove the Motor Clutch – 6.3 from its shaft. The shaft has LEFT HAND threads – remove clutch by turning clockwise.
6.Hold Motor Bracket – 6.4 and loosen Motor Mounting Screws – 6.5. Remove and retain screws and bracket from old motor.
7.Install motor clutch on new motor. Turn counterclockwise to tighten. DO NOT OVERTIGHTEN OR BEND – YOU MAY DAMAGE INTERNAL MOTOR GEARS.
8.Install new motor.
9.Plug cord back in wall outlet, and reset the time.
8