Page 7
»Line the two posts from the mounting plate up with the two holes of the modified end cap. Insert the chase nipples through the holes of the modified end cap and secure to the mounting plate with a 15/16" wrench.
»Slide the front panel assemblies in partially. Secure the required wiring and install the battery if used.
»Slide the front panel assemblies in fully. Install the end caps and secure each with its two screws.
»Discard or store the two original end caps the modified end caps replaced.
mounting plate
modified end caps
DDC4 cases
end cap support
#10 hex nuts | #10 lock washers |
|