Page 6
Double Mount – Wall
The
Tools required for mounting the clock:
Flat blade screwdriver Phillips head screwdriver 15/16" open end wrench
The double wall mount plate attaches to a double or single gang box installed securely in the wall. Required wiring should be available through the gang box at time of installation.
»Remove the two chase nipples from the mounting plate posts.
»Secure the mounting plate securely to the gang box with the
proper screws. (not supplied)
Note: The long dimension of the mounting plate must be perpendicular to the ground to assure proper alignment of wall clocks.
Mounting - Wall
»Remove the two phillips head screws from the left and the right end caps of the two DDC4 clocks and remove. Slide the front panel assemblies out of the cases and set aside.
»Place the two DDC4 clocks back to back and secure by inserting a #10 screw through the two key holes and the two lower mounting holes using lock washers and nuts supplied with the mounting kit.
»Attach the modified end cap to the end of the clocks that will be attached to the wall mount plate using the original end cap screws.
»Align the holes of the end cap support plate with the holes in the modified end cap and secure with 4 #6 phillips head screws (supplied)