Samsung SUR40 manual Mechanical and electrical requirements, Requirement Specifications

Mechanical and electrical requirements

Requirement	Specifications
Strength & stability	Enclosure must not fall over when tilted to an angle of 10° from its
	normal upright position. All doors, drawers, etc. are closed during
	the test. (IEC 60950-1, 2001)
	A floor-standing unit shall not fall over when a force equal to 20 %
	of the weight of the unit, but not more than 250 N, is applied in any
	direction except upwards, at a height not exceeding 2 m from the
	floor. Doors, drawers, etc., which may be moved for servicing by the
	OPERATOR or by a SERVICE PERSON, are placed in their most
	unfavorable position, consistent with the installation instructions.
	(IEC 60950-1, 2001)
	A floor-standing unit shall not fall over when a constant downward
	force of 800 N is applied at the point of maximum moment to any
	horizontal surface of at least 12,5 cm by at least 20 cm, at a height
	up to 1 m from the floor. Doors, drawers, etc., are closed during this
	test. The 800 N force is applied by means of a suitable test tool
	having a flat surface of approximately 12,5 cm by 20 cm. The
	downward force is applied with the complete flat surface of the test
	tool in contact with the EUT; the test tool need not be in full contact
	with uneven surfaces (for example, corrugated or curved surfaces).
	(IEC 60950-1, 2001)
	Enclosure must be able to withstand a static load of 2000 N
	(equivalent to 1.5 Safety factor of unit weight plus 800 N static load).
AC power	100-240 VAC
	15-20A
Minimal heat load	221 Watts/755 BTU/hour
Operating temperature	5°C-30°C ambient

5