YP-60 Quick Guide
Location of Controls
Heart Rate Measurement Sensor |
|
|
| Earphone Jack |
|
| |||
|
|
|
|
|
Connecting the USB cable
➤Before connecting the yepp to PC, make sure to install yepp Studio.
1 Connect a USB cable to the USB port on the computer.
Display
MENU/
Loop Repeating Button
Move to Track/ Speed Search Button
Sports Function Button
USB Cable
Connection Port
ENC Jack
Reset Hole
Hold Switch
Play/Stop/Pause
On/Off Button
Volume Button
ENC/NAVI.
Button
2 Connect the opposite end of the USB cable to the USB cable port on the right side of the yepp.
●If you disconnect the USB cable from your PC while implementing a command or initializing during
USB driver installation, your PC may not function correctly.
3 | The USB driver is installed with a message saying that it |
|
| is searching for a new device. You may not see the | USB |
| display screen during installation. | |
| connect | |
| Go to the device manager to check that | |
|
|
●If the device won’t respond even after pressing the buttons, reboot it by pressing the Reset Hole with a pin.
Turning Power On and Off
●Power On : Press and hold the 
button to turn on the power.
●Power Off : Press and hold the 
button to turn off the power.
Playing Music | Pausing Music | ||||||
Press the |
| button. | Press the |
|
|
| button to pause playback. |
|
|
| |||||
|
|
| |||||
● Playback starts. ● While in Pause mode, briefly press 
again to resume playback.
| installation has been successfully completed. | cable |
4 |
| |
Upon installation of the USB driver |
| |
| ||
| "SAMSUNG |
|
| [Start] → [Settings] → [Control Panel] → |
|
| [System Properties] → [Device Manager]. |
|
1 | 2 |