LED Indications |
| |
:Light is On | :Light is Blinking | :Light is Off |
STAND BY | TEMP | Information |
This state occurs when power is supplied to the projector normally after the POWER button on the projector or the remote control has been pressed.
-This state appears when the projector is preparing an operation after the POWER button on the projector or the remote control has been pressed.
-The POWER button is pressed to turn off the projector, and the cooling system is in operation to cool off the inside of the projector.
The projector is in normal operating condition.
Refer to Action 1 below if the cooling fan inside the projector is not in normal operation condition.
Power is turned off automatically when temperature inside of the projector goes beyond the control limit. Refer to Action 2.
This state occurs when the auto color compensation function has an error. Refer to Action 3.
Clearing Indicator Problems |
| ||
Classification | State | Measures | |
| When the cooling fan system is not in normal | If the symptom remains even after disconnecting and then | |
Action 1 | reconnecting the power cord and turning the projector on | ||
operating condition. | |||
| again, contact your product provider or our service center. | ||
|
| ||
|
| Adjust the installation state of your projector by referring to | |
| When temperature inside of the projector becomes | the Installation Precautions section listed above. Cool | |
Action 2 | down your projector sufficiently and then operate it again. | ||
too high. | |||
| If the same problem occurs continually, contact your | ||
|
| ||
|
| product distributor or service center. | |
| When the sensor system inside the projector is not | Cool your projector down sufficiently and then operate it | |
Action 3 | again. If the same problem occurs again, contact your | ||
operating normally. | |||
| product distributor or service center. | ||
|
| ||
This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan may cause noise, which does not affect the product performance and is part of normal operation.
Rear Side