Samsung SWL-2210M, SWL-2210P user manual Installation Overview, Installation Procedure of Windows

Page 14

3. MagicLAN Installation For Windows 98/ME/NT4.0/2000/XP

We will explain the installation method for SWL-2210M/P (MiniPCI/PCI Card) .

3.1 Installation Overview

Here are some steps you will perform in establishing your wireless network connection:

1.Install the Access Point at first. AP is needed in case of Infrastructure network mode.

2.You should install the Wireless LAN Card (SWL-2210M/P).

3.Install the software using the Installation CD.

4.Install the network protocol(s) required to communicate on your network. Most likely you will need the TCP/IP protocol.

3.2Installation Procedure of Windows 98

Please follow the following steps one by one to install the MiniPCI/PCI card successfully.

<Method 1 - Inserting card first >

1.Insert the MiniPCI/PCI Card into the slot of your computer.

2.Power on your computer and allow Windows 98 to load fully.

3.Add New Hardware Wizard” appeared and the system looks for “PCI Network Controller”. Press ‘NEXT’ button and check if “Search for the best driver for your device(recommended)” is slected and then press ‘NEXT’ button . Insert the MagicLAN Installation CD into the CD-ROM drive.

4.Mark the “Specify a location” tap and type “E:\Drivers” right below in this tap(Where E is the CD-drive of your PC) and then press ‘NEXT’.

14

Image 14
Contents MagicLAN SWL-2210M/P Table of Contents Page Service Dept Important Safety Information 11Mbps High Rate 802.11b Wireless LAN MiniPCI Card 11Mbps High Rate 802.11b Wireless LAN PCI Card FCC Introduction Technical BackgroundServer MagicLAN Overview Scanning, Beaconing & ESS IDPage System Requirement What is in Your Package?Preparations For Installation Method 1 Inserting card first Installation OverviewInstallation Procedure of Windows Page Page Page Page Method 2 Installing software first Installation Procedure of Windows ME Cf. The third methodPage Page Page Method 2 Installing software first Page Cf. The third method Installation Procedure of Windows NT4.0 CASE1 When Windows NT networking is not installedSelect Network Adapter box, click on Have Disk button Page Page Page CASE2 When Windows NT networking is already installed Control Panel Page Page Page Installation Procedure of Windows Page Page Method 2 Installing software first Cf. The third method Installation Procedure of Windows XP Page Page Method 2 Installing software first First Use of Our company’s Utility in Windows XP Adapter Removal Update of MagicLAN Wireless LAN Card DriverRemoval of MagicLAN Wireless LAN Card Driver Utility RemovalPage Installation Procedure Concept of ProfilePage Page Select the WEP Mode and Click the Next button Page Page Main configuration of Program ‘Apply’ button 1Profile‘New’ button ‘Edit’ buttonPage Page Status ‘Delete’ button‘Current Status’ button ‘AP Status’ button‘Site Survey’ button ‘DHCP’ button General SettingsStatistics Version ‘Options’ buttonPage Troubleshooting