Samsung ML-5000A setup guide Selecting a Location, System Requirement, Do not place the printer

Page 13

01-Setup 7/20/99 9:25 AM Page 4

Selecting a Location

Place your printer on a flat, stable surface near your workstation. Leave enough space around the printer, so that you can easily:

¥open the printer cover

¥load the paper

¥retrieve the paper

¥open the front output tray and retrieve the paper from the front output tray

¥allow air circulation around the vents to prevent the printer from overheating

Do not place the printer:

¥In direct sunlight

¥Near heat sources or air conditioners

¥In dusty or dirty environments

System Requirement

Before you start, make sure you have the following computer setup. (These are the minimum requirements.)

¥IBM or compatible with a 386 or higher processor

¥Windows 95, Windows 98, Windows 3.x, or later

¥50 MB of available hard disk space for ML-5000A

¥4 MB of RAM for ML-5000A

¥Centronics-compatible parallel cable (IEEE 1284-compliant)

6Set Up

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Laser Printer Front View Control Locations and FunctionsAutomatic Paper Feeder Manual Paper FeederInsert the paper in the paper feeder Loading a Stack of PaperSet Up Error Windows 95/98/NT4.0 Installation Installing Printer DriverInsert the setup CD-ROM into your CD-ROM drive Turn on the computer and start WindowsWindows 95/98 Plug and Play Windows 3.1x InstallationIf Windows Does Not Run the CD-ROM ManagerFor DOS Users Installing Dosrcp Utility=File, D=directory? Specify directory =File, D=directory? D Windows 95/98 Uninstall Printer DriverWindows Printing a Document Client PC Sharing Setup Setting Up Host PC PrinterPrinting on Network Printer Inside Rear ViewSystem Requirement Selecting a LocationDo not place the printer Unpacking Installing the Toner Cartridge Set Up Connecting the Printer to Your Computer Attaching the Power Cord UserÕs Manual Setup GuideContents Electronics
Top Page Image Contents