Samsung SRP270CPG, SRP270AP user manual SRP-270 Setting the Dip Switches

Page 15

SRP-270

3. Setting the Dip Switches

The DIP switches are located on the bottom of the printer. The DIP switches are used to set the printer to perform various functions. Follow these steps when changing DIP switch settings.

-Turn the printer power switch off.

-Turn the printer over and remove the dip switch cover.

-Move the DIP switches using tweezers or another narrow-ended tool. Switches are on when up and off when down in the figure below.

-The new setting takes effect when you turn on the printer.

※NOTE

Always change DIP switch settings when the printer is turned off. Changes made with the power on have no effect until you turn the printer off and then on again.

Rev. 1.00

- 15 -

Image 15

Contents SRP-270 Do not plug several products in one multi-outlet SRP-270 Safety PrecautionsTo Unplug SRP-270Label Material Waste Electrical and Electric Equipment WeeeSRP-270 Introduction ※ All specifications are subjected to change without noticeTable of Contents SRP-270 Setting Up the Printer Manual Installing the PrinterUnpacking Functions Connecting the AC adapter to the printer SRP-270 Connecting the cablesConnecting Interface Cable and Drawer Cable to the printer RTS Fgnd GND USB Connector SRP-270 Setting the Dip Switches Serial Interface Parallel / USB Interface SRP-270 Ribbon Cassette Installation SRP-270 Roll Paper Installation SRP-270 SRP-270 ※ Note ※ Caution SRP-270 Removing Jammed PaperSRP-270 ※ Note SRP-270 Self Test Self-test printing Please press the Feed buttonCharacter Test Completed SRP-270 Hexadecimal Dumping SRP-270D/DS/DP/DU SRP-270 Specification