Samsung SRP270AP, SRP270CPG SRP-270 Self Test, Self-test printing Please press the Feed button

Page 26

SRP-270

7. Self Test

The self-test checks whether the printer has any problems. If the printer does not function properly, contact your dealer.

7-1 Make sure paper roll has been installed properly.

7-2 Turn on the power while holding down the FEED button. The self-test begins.

7-3 The self-test prints the current printer status, which provides the control ROM version and the DIP switch setting.

7-4 After printing the current printer status, self-test printing will print the following, and pause (The PAPER LED light blinks).

Self-test printing.

Please press the FEED button

7-5 Press the FEED button to continue printing. The printer prints a pattern using the built- in character set.

7-6 The self-test automatically ends after printing the following.

** Character Test Completed **

7-7 The printer is ready to receive data when it completes the self-test.

Rev. 1.00

- 26 -

Image 26
Contents SRP-270 SRP-270 Safety Precautions Do not plug several products in one multi-outletSRP-270 To UnplugWaste Electrical and Electric Equipment Weee Label Material※ All specifications are subjected to change without notice SRP-270 IntroductionTable of Contents Unpacking SRP-270 Setting Up the PrinterManual Installing the Printer Functions SRP-270 Connecting the cables Connecting the AC adapter to the printerConnecting Interface Cable and Drawer Cable to the printer RTS Fgnd GND USB Connector SRP-270 Setting the Dip Switches Serial Interface Parallel / USB Interface SRP-270 Ribbon Cassette Installation SRP-270 Roll Paper Installation SRP-270 SRP-270 ※ Note SRP-270 Removing Jammed Paper ※ CautionSRP-270 ※ Note Character Test Completed SRP-270 Self TestSelf-test printing Please press the Feed button SRP-270 Hexadecimal Dumping SRP-270 Specification SRP-270D/DS/DP/DU