graphic card? | http://www.samsung.com/monitor/magictune. |
Visit our website and download the installation software for MagicTune™ MAC.
Check the following items if there is trouble with the monitor.
1.Check if the power cord and the video cables are properly connected to the computer.
2.Check if the computer beeps more than 3 times when booting.
(If it does, request an
3.If you installed a new video card or if you assembled the PC, check if the installed the adapter (video) driver and the monitor driver.
4.Check if the scanning ratio of the video screen is set at 56Hz ~ 75Hz. (Do not exceed 75Hz when using the maximum resolution.)
5.If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, remove the Display Adapter at the "Control Panel→System→Device Administrator" and then reboot the computer to reinstall the adapter (video) driver.
If problems repeatedly occur, contact an authorized service center.
Q & A
Question
How can I change the frequency?
Answer
Frequency can be changed by reconfiguring the video card.
Note that video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details.)
How can I adjust the resolution? Windows ME/XP/2000 : Set the resolution at the Control
| Panel→Display→Settings. |
| * Contact the video card manufacturer for details. |
How can I set the Power Saving | Windows ME/XP/2000 : Set the function at |
function? | computer or the screen saver. (Refer to Windows/Computer |
| Manual). |
How can I clean the outer | Disconnect the power cord and then clean the monitor with a soft |
case/LCD Panel? | cloth, using either a cleaning solution or plain water. |
| Do not leave any remains of the detergent nor scratch the case. |
| Do not allow any water to go inside the monitor. |
Self-Test Feature Check
Your monitor provides a self test feature that allows you to check whether your monitor is functioning properly.
1.Turn off both your computer and the monitor.
2.Unplug the video cable from the back of the computer.
3.Turn on the monitor.
If the monitor is functioning properly, you will see a box in the illustration below.