Samsung 997MB, 797MB manual General Q & a, Panel , Display , Settings, Highlight Zone III Q & a

Check List

Q & A

Self-Test Feature Check

General Q & A Highlight Zone III Q & A

1. General Q & A

Question	Answer
How can I change the frequency?	Frequency can be changed by reconfiguring the video
	card.
	Note that video card support can vary, depending on the
	version of the driver used.
	(Refer to the computer or the video card manual for
	details.)
How can I adjust the resolution?	Windows ME/XP/2000: Set the resolution at the Control
	Panel, Display, Settings.
	* Contact the video card manufacturer for details.
How can I set the Power Saving	Windows ME/XP/2000: Set the function at BIOS-SETUP
function?	of the computer or the screen saver. (Refer to
	Windows/Computer Manual).
The monitor makes a sound when it	This is normal as some sound may be generated when
is turned on.	the metal case and the electromagnet, which are installed
	to block any electromagnetic waves, interact with each
	other.
How can I clean the outer	Disconnect the power cord and then clean the monitor
case/Picture tube?	with a soft cloth, using either a cleaning solution or plain
	water.
	Do not leave any remains of the detergent nor scratch the
	case. Do not allow any water to go inside the monitor.

2. Highlight Zone III Q & A

Question Answer

The program does not function properly.

Started a multimedia program but the Highlight Zone function does not

Highlight Zone III features a combination of circuitry and software built on proprietary technology of SEC. Therefore, the Highlight Zone III feature is found only on SEC monitors that support the feature.

Check if your monitor supports the Highlight Zone III feature.

If not, the Highlight Zone III icon will show a message

saying, "No Connection" ()Connect the monitor properly before using it. Neither Automatic Detect or nor Manual Detect function while the icon shows the message, "No Connection". You can only exit the program.

Check the Highlight Zone III menu and see if Disable Auto Detect is selected.