Samsung 914V manual PowerSaver, Preset Timing Modes

Page 45

428.0 X 61.8 X 356.0 mm / 16.9 x 2.4 x 14.0 inch (Without Stand)

428.0 X 195.7 X 430.0 mm / 16.9 x 7.7 x 16.9 inch (With Basic Stand) / 5.55kg

VESA Mounting Interface

100mm x 100mm (for use with Specialty(Arm) Mounting hardware.)

Environmental considerations

Operating

Temperature: 50°F ~ 104°F(10°C ~ 40°C)

 

Humidity: 10% ~ 80%, non-condensing

Storage

Temperature: -4°F ~113°F (-20°C ~ 45°C)

 

Humidity: 5% ~ 95%, non-condensing

Plug and Play Capability

This monitor can be installed on any Plug & Play compatible system. Interaction of the monitor and computer systems will provide the best operating conditions and monitor settings. In most cases, monitor installation will proceed automatically, unless the user wishes to select alternate settings.

Dot Acceptable

TFT LCD panel manufactured by using advanced semiconductor technology with precision of 1ppm (one millionth) above is used for this product. But the pixels of RED, GREEN, BLUE and WHITE color seem to be bright sometimes or some of black pixels could be seen. This is not from bad quality and you can use it without uneasiness.

zFor example, the number of TFT LCD sub pixels that is contained in this product are 3,932,160.

Design and specifications are subject to change without prior notice.

PowerSaver

This monitor has a built-in power management system called PowerSaver. This system saves energy by switching your monitor into a low-power mode when it has not been used for a certain amount of time. The monitor automatically returns to normal operation when you press a key on the keyboard. For energy conservation, turn your monitor OFF when it is not needed, or when leaving it unattended for long periods. The PowerSaver system operates with a VESA DPMS compliant video card installed in your computer. Use a software utility installed on your computer to set up this feature.

State

Normal Operation

Power saving mode

Power Switch off

EPA/ENERGY 2000

 

 

 

Power Indicator

Green

Green, Blinking

Black

Power Consumption

Less than 38W

Less than 1W

Less than 1W

(Off-mode)

(230 Vac)

 

 

This monitor is EPA ENERGY STAR® compliant and ENERGY2000 compliant when used with a computer equipped with VESA DPMS functionality.

As an ENERGY STAR® Partner, SAMSUNG has determined that this product meets the ENERGY STAR® guidelines for energy efficiency.

Preset Timing Modes

If the signal transferred from the computer is the same as the following Preset Timing Modes, the screen will be adjusted automatically. However, if the signal differs, the screen may go blank while the power LED is on. Refer to the video card manual and adjust the screen as follows.

Image 45
Contents SyncMaster Power NotationalDo not use a damaged or loose plug Insert the power plug firmly so that it does not come loose InstallationDo not drop the monitor when moving it Use only a properly grounded plug and receptacleDo not place the product on the floor Keep any heating devices away from the power cableSet down the monitor carefully Do not place the monitor face downDo not spray water or detergent directly on the monitor CleanDo not remove cover or back OthersNever insert anything metallic into the monitor openings Do not cover the vents on the monitor cabinetFalling product could cause physical damage even death Unpacking Quick Setup GuideMonitor Bottom Hanger Manual Not available in all locationsCustom FrontRear For using a locking device, contact where you purchase itSub 15-pin port Kensington LockConnecting the Monitor Using the StandMonitor Assembly Attaching a Base Installing the Monitor Driver AutomaticWindows XP/2000 Installing the Monitor Driver ManualClick Windows XP/2000 Driver Microsoft Windows XP Operating SystemPage Page How to install Click Start , Setting , Control Panel Microsoft Windows NT Operating SystemLinux Operating System How to install the Natural Color software Natural ColorNatural Color Software Program Auto MagicBright MenuDescription Adjust Brightness BrightnessPicture Image ColorDescription Play/Stop Color Tone Color Control GammaCoarse Fine Sharpness Position OSDSetup InformationLanguage Position Transparency Display Time Shows a video source, display mode on the OSD screen What is MagicTune? OSD ModeBasic Functionality Installation Page Installationation Problems Hardware Picture Tab Definition Button Tab DefinitionBrightness Color Tab DefinitionColor Tone Image Tab DefinitionOption Tab Definition Image SetupPreferences Support Tab DefinitionPreview Color CalibrationPage Uninstall Troubleshooting Can you see Check Signal Cable on the screen? SymptomMode,Recommanded Mode 1280 x 1024 60Hz on the screen? SolutionsPanel → Display → Settings Refer to the Preset Timing ModesSelf-Test Feature Check Useful Tips General Preset Timing Modes PowerSaverSync Polarity Preset Timing ModesHorizontal Frequency Vertical FrequencyAustralia Brazil ServiceGermany United Kingdom PortugalFor Better Display TermsClass B AuthorityWhat is Image retention ? Power Off, Screen Saver, or Power Save ModeSuggestions for specific applications