Samsung 226CW manual Connecting Cables, Using the Stand, Monitor Assembly

Page 15

Model

SyncMaster 226CW

Connecting Cables

Connect the power cord for your monitor to the power port on the back of the monitor. Plug the power cord for the monitor into a nearby outlet.

Use appropriate connection for your computer.

Using the D-sub (Analog) connector on the video card.

- Connect the signal cable to the 15-pin, D-sub port on the back of your monitor.

[RGB IN]

Using the DVI (Digital) connector on the video card.

- Connect the DVI Cable to the DVI IN (HDCP) port on the back of your Monitor.

[DVI IN (HDCP)]

Connected to a Macintosh.

-Connect the monitor to the Macintosh computer using the D-sub connection cable.

If the monitor and the computer are connected, you can turn them on and use them.

Using the Stand

Monitor Assembly

Image 15

Contents SyncMaster 226CW Notation PowerPage Installation Page Others Cleaning and UsePage Page Good Postures When Using the Monitor Page Package Contents FeaturesSold separately Monitor & Simple stand ManualCable OthersFront Your MonitorRear Not available in MagicBright mode of Dynamic ContrastConnecting Cables Using the StandMonitor Assembly Tilt angle Swivel standAttaching a Base Page Monitor Driver Installing the Monitor Driver AutomaticInstalling the Monitor Driver Manual Page Page Page Page Page Natural Color Software Program How to install the Natural Color softwareHow to delete the Natural Color software program Natural ColorUninstall Installation Direct Functions Control ButtonsOSD Lock & Unlock AutoMagicBright Brightness OSD OSD FunctionColor Not available in MagicBright mode of Dynamic Contrast Image OSD RTA SetupInformation Or contact your dealer Check ListInstallation Instructions Feature is found only Self-Test Self-Test Feature CheckUseful Tips EnvironmentSpecifications EPA/ENERGY PowerSaverPreset Timing Modes Preset Timing ModesPage Contact Samsung Worldwide Belgium Terms Authority For Better DisplayProduct Information Image Retention Free