Samsung PS-42A5S manual To mount the product on the wall bracket

Installing the Display on the Wall Attachment Panel (continued)

To mount the product on the wall bracket

◆The shape of the product may vary depending on the model. (The assemblies of the plastic hanger and the screw are the same)

1	Remove the 4 screws on the back of the product.	2	Insert the screw into the plastic hanger.
			(See the figure below)
			☛ ◆ Mount the product on the wall bracket
			and make sure it is properly fixed to
			the left and right plastic hangers.
			◆ Be careful when installing the product
			on the bracket as fingers can be
			caught in the holes.
			◆ Make sure the wall bracket is securely
			fixed to the wall, or the product may not
			stay in place after installation.
3	Tighten the 4 screws in step 2 (plastic hanger	4	Remove safety pin (#) and insert the 4 product
	+ screw ) to the rear holes of the product.		holders into the corresponding bracket holes (!). Then
			place the product (@) so that it is firmly fixed to the

bracket. Make sure to reinsert and tighten the safety pin (#) to securely hold the product to the bracket.

PDP Monitor

Wall Bracket Wall

Wall Bracket Angle Adjustment

➢Adjust the bracket angle to -2obefore installing it on the wall.

1Fix the product to the wall bracket.

2Hold the product at the top in the center and pull it forward (direction of the arrow) to adjust the angle. (See the figure to the right)

3You can adjust the bracket angle between -2° and 15°.

Make sure to use the top center, and not the left or the right side of the product to adjust the angle.

English - 11