Fitting the apex 10 to a wall/ ceiling
To fix the Apex 10 to a wall or ceiling, follow the step by step instructions below. The Apex 10 can be wall mounted horizontally (for use as a centre channel), the template just needs to be rotated.
•We do not supply fixing screws or wall plugs with these products so please purchase these separately choosing appropriate length screws (40mm (1 3/4”) minimum) and the correct plugs for the wall/ ceiling the loudspeaker will be fixed to.
•After the location for the Apex 10(s) has been decided, use the supplied template to mark the fixing points and cable hole. Ensure there are no electrical cables or gas/ water pipes behind the proposed location.
•With the holes marked, proceed to drill them using the correct size drill bit for the wall plugs.
•Assemble the wall plate and components. For ceiling mounting, assemble the wall plate, bracket extension pole and pivot together using the long bolts. For wall mounting, the extension pole is not required and the shorter bolts should be used. Refer to the configurations on pages 9 & 10.
•Depending on the desired angle to aim the Apex 10, it might be necessary to change the side the clamp screw is located on. In this case, loosen the screw and flip the clamp arms over so the clamp screw is on the opposite side.
•Fix the wall plate to the wall/ ceiling and press the rubber pad (with through hole) into place.
•Connect the cables to the terminals on the speaker and align the clamp arms on the cabinet with the pivot on the assembled wall plate.
•Align the speaker to the direction it will be pointing and tighten the clamp screw.
•Take a step back to ensure it is correctly aligned. If not, loosen the clamp screw slightly and adjust the angle and repeat the above step.
DO NOT try to adjust the angle of the speaker with the clamp screw tightened.
THIS MAY CAUSE DAMAGE AND INVALIDATE YOUR WARRANTY.
Apex 10 Ceiling
Fixing Template
CABINET (inc grille)
FRONT OF WALL PLATE
Fixing Point Centres
Cable Through
Hole
Fixing Point Centres
This template shows the fixing points to secure
the Apex 10 to a ceiling. L
C
CL
Apex 10 Wall
Fixing Template
CABINET
TOP OF WALL PLATE | |
Fixing Point Centres | |
Cable Through | |
| Hole |
Fixing Point Centres | |
This template shows the |
|
fixing points to secure | L |
the Apex 10 to a wall. | C |
Cabinet
C
L
C
L
8 | monitoraudio.co.uk |