Apex Digital 10 owner manual Fitting the apex 40 to a wall

Page 16

Fitting the apex 40 to a wall

To fix the Apex 40 to a wall (horizontally or vertically), follow the step by step instructions below:

•We do not supply fixing screws or wall plugs with these products so please purchase these separately choosing appropriate length screws (40mm (1 3/4”) minimum) and the correct plugs for the wall/ ceiling your loudspeaker will be fixed to.

•When the location of the Apex 40(s) has been decided, use the supplied template to mark the fixing points and cable hole. The Apex 40 can be secured using just 2 fixings, but additional fixing points are incorporated if required. Ensure there are no electrical cables or gas/ water pipes behind the proposed locations.

•With the holes marked, proceed to drill them using the correct size drill bit for the wall plugs being used.

•Remove the bracket from the cabinet by loosening the grub screws at each end of the cabinet.

•Fix the bracket to the wall.

•Connect the cables to the terminals on the speaker and align the ends of the bracket with the apertures in the rear of the cabinet.

•If the cabinet is to be angled slightly, do not push the cabinet fully onto the bracket. This allows for some angular adjustment. Tighten the grub screw to take the weight of the cabinet, and take a step back to check the alignment. If correctly aligned, check the grub screw is secure and press the rubber grub screw covers into place. If further adjustment is required, loosen the grub screw slightly, adjust and re-tighten until the correct position is found. Refer to figures 2 & 3 opposite.

•If the Apex 40 is to be used pointing directly ahead, push the cabinet fully onto the bracket and tighten the grub screw. Refer to figures 4 & 5 opposite.

•If the Apex 40 is to be used with the grille on, the badge can be added to either of the locations depending on orientation. An illustration of this can be seen on page 16.

DO NOT try to adjust the angle of the speaker with the grub screw tightened.

THIS MAY CAUSE DAMAGE AND INVALIDATE YOUR WARRANTY.

Apex 40 Wall Fixing Template.

Horizontally and Vertically

Fixing Points

Fixing Points

 

The Apex 40 will be secure using just 2 fixings (one at each end).

 

Others are provided for added security and alternative configurations.

shows the

to secure

to a wall.

This template

fixing points

the Apex 40

14

monitoraudio.co.uk

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Apex Page Contents Important Safety Instructions RoHS Declaration of Conformity BackgroundUnpacking ApexIntroduction Positioning Front Speakers Setting up and PositioningPositioning Surround Speakers Optimum positioning This MAY Cause Damage and Invalidate Your Warranty Fitting the apex 10 to a wall/ ceilingApex 10 Fixing Configurations Wall Mounting Exploded Wall Mounting FixedCeiling Mounting Exploded Ceiling Mounting FixedTable Mounting Exploded Table Mounting AssembledApex 10 Horizontally on a Table/ Shelf Exploded Adhesive Feet FixedAdjusting the Apex 10 bracket assembly Fitting the apex 40 to a wall Apex 40 Wall Fixing Template Horizontally and VerticallyApex 40 Fixing Configurations Wall Mounting Exploded Cabinet Bracket Grub ScrewGrille Badge Fixing Specifications Guarantee and Service Claims under this GuaranteeEC Declaration of Conformity LVD 73/23/EEC Low Voltage DirectiveData Protection Owner InformationPage Version
Top Page Image Contents