Samsung S3F401F manual Features, SW6, Uart, Led, System Requirements

EVALUATION BOARD MANUAL S3F401F_BD_UM_REV1.00

1.1 FEATURES

Micro-Controller	S3F401F, ARM7TDMIS, 16/32-bit RISC Microcontroller
Board Power Source	External DC 7~12V
	Adjustable voltage regulator out is 3.2V
Board Master Power Switch	SW6
UART	Support to protocol for RS-232
	Physical interface circuit connected to standard PC through DB9(female)
	Interface driver IC MAX3221
Synchronous Serial Port	Provide SSP, SPI serial communication with external devices (master or slave)
	SSP serial EEPROM (8K * 8bit): X25650
	SSP serial EEPROM (4K * 16bit): 64LC40S
LED	IO Port output control display
JTAG Connection	20Way JTAG connector (Multi-ICE Interface, Trace 32 etc.)

1.2 SYSTEM REQUIREMENTS

This section describes the hardware and software system requirements.

Software Requirements	ARM Compiler SW
	ARM Debugger SW
Hardware Requirements	S3F401F EVB Board Set
	Power Supply DC 7~12V ( Recommend Default 12V)
	Debugger (Multi-ICE or Trace 32 etc.)
	PC(Pentium, 32MB RAM for Windows 95, or 64MB RAM for Windows NT)
	COM Port for serial communication
	Parallel Port (If using Multi-ICE)

3