Troubleshooting Guide
To assist in location possible faults use help guide below.
Troubleshooting
No picture, no sound | Verify if the television is properly plugged. | |
Verify if the television is properly supplied power. | ||
| ||
| Verify if electricity is available. | |
|
| |
Blank screen | Verify if correct signals are input. | |
Press TV/AV button to change signal input to TV input. | ||
| Restart the television of power supply is interrupted. | |
|
| |
| Press MUTE button and verify if Mute mode is set. | |
No sound | Switch to other channel and verify if the same problem | |
happens. | ||
| ||
| Press VOL+ button to see if the problem can be solved. | |
Poor sound | Verify if sound system is correct. Refer to some chapter | |
for adjust. | ||
| ||
|
| |
No picture in some | Verify if correct channel is selected. | |
Adjust the antenna. | ||
channel | ||
Make adjustments by FINE TUNE and MANUAL SEARCH. | ||
| ||
|
| |
No color for some channel | Verify if the same problem exists in other channels. | |
Check out of picture and sound systems. | ||
program (black and white) | Refer to relative instructions in the Manual for color | |
| adjust. | |
|
| |
| Verify if the antenna is correctly connected. | |
Spots with some or | Verify if the antenna is in good condition. | |
all pictures | Make fine adjustment of channel. | |
|
| |
| Disconnect the television from power supply and, 10 | |
Television out of control | seconds later, connect the television to the power supply. | |
If the problem still exists, contact authorized | ||
| ||
| service for technical assistance. | |
|
|
Note:
1.If the fault can not be repaired using the above guide consult with your local authorized service center.
2.The TV set must only be repaired by a qualified registered service person. Never attempt to remove the back cover as the TV set has dangerous voltages in side that may cause a fatally or fire.